Volvo Penta D4 Operator's Manual page 18

Presentation
Fresh water level
Fresh water level can be displayed on the EVC sys-
tem tachometer if a (3-180 ohm) fuel level sender is
installed in the water tank. The sender is connected to
the PCU–engine cable harness. If a fresh water level
gauge is used it must be connected to the instrument
serial communication bus.
Rudder indicator
Rudder angle can be displayed on the EVC system
tachometer if a (3-180 ohm) rudder indicator is in-
stalled to the drive/rudder. The sender is connected to
the PCU–engine cable harness. If a rudder instrument
is used it must be connected to the instrument serial
communication bus.
Multisensor (Boat speed, depth and water temp)
Boart speed, depth and water temperature canbe dis-
played on the EVC system tachometer if a multi sen-
sor is installed on the boat. The sensor is connected
to the multilink cable. If instruments (speed, depth,
water temp.) are used they must be connected to the
instrument serial communication bus.
Power Trim Assistant
The function power trim assistant adjust trim angle
automatically according to engine speed (rpm). EVC
supports power trim assistant if software for power-
trim assistance is installed (order and download from
VODIA website).
Boat speed
Boat speed can be shown on the EVC system ta-
chometer, if a multisensor or NMEA 0183/NMEA 2000
compatible component (plotter, GPS, paddle wheel
etc) is installed. If a speedometer is used it must be
connected to the instrument serial communication
bus. .
Trip computer
EVC supports trip computer functions if following are
installed.
- Multisensor or NMEA 0183/NMEA 2000 compat-
ible component (plotter, GPS, paddle wheel etc)
- Fuel level sender
- Software for trip computer (order and download
from VODIA website).
Trip computer information can be displayed on the
EVC system tachometer or/and on the optional EVC
system display.
16