Table of Contents
Advertisement
Monitor Settings
AUTO ADJUST (For D-SUB (RGB) input only)
The display position in the horizontal and vertical directions, horizontal size, and phase are automatically adjusted.
For detailed procedures on automatic adjustments, refer to "Performing Auto Adjust" (Page 17).
SCREEN SIZE
Function that automatically expands the display screen. This function is enabled when the resolution of the input
signal is lower than the number of display pixels.
Full: The input picture signal is expanded to cover the entire screen. If a signal other than 16:10 is input for the
aspect ratio (horizontal to vertical ratio), the aspect ratio changes.
Aspect: Expands the picture signal to cover as much of the screen as possible, while maintaining the aspect ratio of
the input picture signal. Consequently, the display screen is not fully expanded in either the vertical or horizontal
direction, depending on the picture signal that is input.
Real: The input picture signal is displayed in its actual resolution. (The screen is not expanded).
2x Zoom: The resolution of the input picture signal is expanded by 2x vertically and horizontally and displayed.
NOTE: • When Screen Size is set to a setting other than [Full], there may be cases where PIP is not able to be
displayed. In such cases, set Screen Size to [Full].
• For some resolutions, the input picture signal is not expanded to cover the entire screen. Depending on
the input signal, the display screen may not be fully expanded in either the vertical or horizontal direction.
• The 2x Zoom function is active only when a resolution signal of 960 x 600 or smaller is input.
If a larger resolution signal is input, the signal is displayed in [FULL] even if [2x ZOOM] is selected.
• When THROUGH MODE is on, [REAL] and [2x ZOOM] cannot be selected.
LEFT/RIGHT (For D-SUB/DVI (AV) input only)
The adjustment bar (0.0% to 100.0%) is displayed. Move the
the
control buttons on the remote control and adjust the display position in the horizontal direction.
DOWN/UP (For D-SUB/DVI (AV) input only)
The adjustment bar (0.0% to 100.0%) is displayed. Move the
the
control buttons on the remote control and adjust the display position in the vertical direction.
HORIZONTAL SIZE (For D-SUB input only)
Adjust the horizontal size when vertical stripes appear on the screen or when the width of the screen size needs to
be adjusted.
The adjustment bar (0.0% to 100.0%) is displayed. Move the
the
control buttons on the remote control and adjust the horizontal size.
RESOLUTION SWITCHING (For D-SUB input only)
It is possible to directly specify the resolution of the input signal manually. Depending on the input signal, there may
be cases where the correct resolution cannot be automatically determined. In such cases, it is possible to directly
specify a resolution using this function and display the screen in the specified resolution.
NOTE: If a resolution signal other than one that is displayed on the OSD (e.g. 640 x 480) is input, this function does
is disabled.
PHASE (For D-SUB input only)
Adjust the phase when noise in the horizontal direction is displayed on the screen, or blurring of text or fuzziness of
contours occurs.
The adjustment bar (0.0% to 100.0%) is displayed. Move the
the
control buttons on the remote control and adjust the phase.
Color Control
It is possible to adjust the colors of the screen according to your taste. You can also store the values to which the
ratio of the colors was changed.
NOTE: When [sRGB] is selected for DV MODE, color control is not possible.
Downloaded from ManualMonitor.com Manuals
button of the monitor in the
button of the monitor in the
button of the monitor in the
button of the monitor in the
English-25
directions, or press
directions, or press
directions, or press
directions, or press
Hide quick links:
Advertisement
Table of Contents
