Table of Contents
Advertisement
Cautions during
1. Installation
• Do not install the unit in the following places.
Where there is lots of moisture.
Where it is hit by direct
sunlight.
Where there is lots of dust.
Where the temperature is very high or low.
Where there is lots of vibration.
• Install the unit as level as possible.
• Do not install the unit near machines that generate lots of
noise.
Also, use a power source
diffe
rent from that used by such machines.
• Use the power source voltage shown on the rating plate on the back of the unit.
2. Cautions during Operation
• Do not touch the printing head with your hand during operation because it becomes very hot.
• Immediately pull out the power cord if water or liquid or metal objects such as a wire or pin gets
inside the unit by mistake. Then completely remove these foreign objects.
• Always be sure the braided wire, etc. are completely connected when operating this machine.
(Refer to page 4 or 5.)
3. Screws to Fasten Printing Mechanism
The printing mechanism is fastened to the chassis with four screws to prevent it from being damaged
by vibration during transit.
Remove these screws before using the unit. When transporting it again,
refasten the mechanism with these screws. Keep the screws that you remove for that purpose.
STEP 1. Remove the two fastening screws that are on the
bottom of the printer cabinet.
STEP 2. Remove the screws holding the mechanism.
When the printing head is all the way to the left,
there is one screw in the chassis between the belt
to the right side of it and another fastening
screw in the right end of the horizontal direc
tion.
STEP 3. Put the printer cover back. Keep the fastening
screws that you removed.
Remove the fastening screws
o
Cl
0
11
0
1111111111
0
1111011111
1III
II
II nl
1111
1111111
1
11
0
6
0
11111111111
r;
o
~
BB
2
Advertisement
Table of Contents
