Sharp MZ-80P6 Instruction Manual page 8

2. When connecting to MZ-80K
STEP 1. Connect the MZ-80K and interface unit MZ-801/0.
Refer to the explanation of the interface unit for
the connecting method.
STEP 2. As shown in the figure on the right, remove the
two screws and the side cover of the interface unit.
STEP 3. Pass the signal cable through the cable inlet in the
back of the interface unit.
STEP 4. Connect the I/O card connector and signal cable.
Use the smaller end of the signal cable. When
making the connection, match the polarity mark
(~)
of the I/O card and polarity mark (A) of the
connector of the cable. (Refer to the figu re on the
right.)
STEP 5. Insert this I/O card in an appropriate place in one
of the five si its.
STEP 6. Replace the side cover removed in STEP 2 and
tighten the two screws.
STEP 7. In the same way as in STEP 4 on page 4, connect
the other end of the signal cable connector to the
printer signal terminal and fasten with screws.
STEP 8. I n the same way as in STEP 5 on page 4, connect
one end (round lug terminal) to the FG terminal of
the printer and the other end ("U" shaped lug ter ­
minal) to the FG terminal of the interface unit.
(Interface unit)
Remove screws.
Side cover
Connector
Guide
Polarity mark
Support Angle
Guide
Back of MZ-80P6
5