S
D
ECTION
To support Japanese Double Field Bar Codes, first make sure you have your scanner configured to
the following settings.
•
Disable Segmented UPC Decoding
•
Enable 2 scan buffers
•
Disable bar code absence detection
•
Enable normal code selects
Then, scan the Enable Japan 2 Field bar code.
Enable Japan 2 Field
³
1
2
4
7
1
Next, select the matching bar codes that are used for double field symbols.
Note that only UPC/EAN bar codes are allowed in double field mode.
Select at least two characters for each bar code. The maximum is 4 upper and 4 lower bar codes.
E
XAMPLE
To select 54 as the first two characters in the Upper Code pair 1:
1. Scan the Upper Code 1 Character 1 bar code (shown on page D 31)
2. Determine the correct Code Byte Value for the character 5 in 54
(Refer to Section M's ASCII Reference Table, starting on page M 6)
3. Scan the Upper Code 1 Character 2 bar code (shown on page D 31)
4. Determine the correct Code Byte Value for the character 4 in 54.
To select 18 as the first two characters in the Lower Code pair 1:
1. Scan the Lower Code 1 Character 1 bar code (shown on page D 31)
2. Determine the correct Code Byte Value for the character 1 in 18
(refer to Section M's ASCII Reference Table starting on page M 6)
3. Scan the Lower Code 1 Character 2 bar code (shown on page D 31)
4. Determine the correct Code Byte Value for the character 8 in 18.
(Refer to Section M's ASCII Reference Table, starting on page M 6)
Scanner Operation
J
3
a. Scan Code Byte 0
b. Scan Code Byte 5
c. Scan Code Byte 3
a. Scan Code Byte 0
b. Scan Code Byte 5
c. Scan Code Byte 2
a. Scan Code Byte 0
b. Scan Code Byte 4
c. Scan Code Byte 9
a. Scan Code Byte 0
b. Scan Code Byte 5
c. Scan Code Byte 6
D
D
APANESE
OUBLE
30
F
S
IELD
UPPORT
* Disable Japan 2 Field
³
1
2
4
7
0
3