To Set At A Desired Speed; To Deactivate; To Resume Speed; To Vary The Speed Setting - Jeep 2009 Wrangler Owner's Manual

WARNING!
Leaving the Electronic Speed Control system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have an accident. Always
leave the Electronic Speed Control system OFF when
you are not using it.

To Set At A Desired Speed

When the vehicle has reached the desired speed, press
down on the lever and release. Release the accelerator
and the vehicle will operate at the selected speed.
NOTE: The vehicle should be traveling at a steady
speed and on level ground before pressing the SET lever.

To Deactivate

A soft tap on the brake pedal, pulling the Electronic
Speed Control lever towards you, or normal brake or
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 103
clutch pressure while slowing the vehicle will deactivate
Electronic Speed Control without erasing the set speed
memory. Pressing the ON/OFF button or turning off the
ignition switch erases the set speed memory.

To Resume Speed

To resume a previously set speed, push the RESUME
ACCEL lever up and release. Resume can be used at any
speed above 20 mph (32 km/h).

To Vary The Speed Setting

When the Electronic Speed Control system is ON, speed
can be increased by pushing up and holding RESUME
ACCEL. Release the Electronic Speed Control lever when
the desired speed is reached, and the new speed will be
set.
Tapping RESUME ACCEL once will result in a 1 mph
(1.6 km/h) speed increase. Each time the Electronic
Speed Control lever is tapped, speed increases so that
3