Glass Cleaning; Section Three; Cleaning - Infinity 660 PC Owner's Manual

660 PC Users Instructions

SECTION THREE

Warning: -
Before you clean any part of the appliance ensures that the appliance is turned off and cold.
CLEANING: FASCIA
Abrasive or chemical cleaner should never be used.
CLEANING: BLACK PAINTED SURFACES

These surfaces should be dusted regularly and any marks removed with a soft cloth.

Abrasive or chemical cleaner should never be used.
CLEANING: PILOT ASSEMBLY
(Before cleaning ensure that the appliance is turned off and
cold)
In some instances you may experience ignition problems even
when the appliance is new. This may be due to the aeration hole
in the pilot body (see photograph) being partial blocked with
dust, pet hairs, or other foreign matter. The source of this debris
could be such things as carpet fibres, decorating or pets etc.
To gain access to the pilot, remove the ash pan cover and fret or
fascia.
The pilot is located on the right hand side of the appliance, any
debris in or around the aeration hole should be remove using
the nozzle of a vacuum cleaner. It is advisable not to blow the
debris into the hole as this may cause more of a restriction and
not rectify the problem.
Note: - Take care when cleaning in this area so as not to damage the pilot assembly.

GLASS CLEANING

From time to time it will be necessary to clean the glass panel of your 660 PC fire. We recommend
you use a Ceramic hob cleaner these are available for all leading super markets: - i.e. ASDA,
TESCO, SAINSBURY'S Etc.
Brands of hob cleaning we have tested and found suitable are - HOB BRITE & VITRO CLEAN.

Ensure the fire as been turned OFF for at least four hours to ensure it is cool.

Remove the glass panel as described below.

Lay the glass panel down on a flat working surface on top of an old opened newspaper with the
side to be cleaned uppermost.

Follow the instructions on the Hob Cleaner Bottle.

On stubborn stains (where the appliance as been used for a long period without glass panel being
cleaned), use a new Brillo Pad well wetted with the Hob cleaner applied directly to it.

Ensure all the residues of the cleaner are removed with a damp cloth and the glass panel is
completely dry before fitting to the appliance.
Important: - The appliance must not be used if the glass panel is missing or damaged.
Note: - The glass may discolour quickly when first installed, and it should be cleaned. This is
due to the burning off process of the refractory shapes.
*The top of the outer firebox is not a working surface and therefore you should avoid placing
items on top*

Cleaning

8 LT6159 issue 7(06/13)