Section Two - Infinity 660 PC Owner's Manual

660 PC Users Instructions
SECTION ONE

Care must be taken to prevent any damage being caused to surrounding soft furnishing or
decoration; e.g. many embossed vinyl wall coverings may become discoloured if placed too close
to the appliance. Combustible material i.e. wall panelling or wallpaper must be removed from
behind the fire and fire fascia.

It is advised that this appliance is serviced annually; as it is more likely to provide trouble-free
operation.

In GB (Great Britain) the fire does not normally require purpose built ventilation, but if for any
special reason purpose built ventilation is provided it should be checked periodically to ensure
freedom from obstructions.

In IE (Ireland) permanent ventilation must comply with the current edition of IS813.

SECTION TWO

To light the appliance using the remote hand set:
a. Point the remote control hand set in the direction of
the appliance and press the
hold the button for approximately 2 seconds and
release. When released a bleep should be and heard
the appliance will automatically go through the ignition
sequence and the pilot should ignite. Once the pilot is
alight the appliance will automatically go to the high
setting (approximately 20-25sec).
b. If the ignitor stops sparking and the pilot fails to light
press the
release, again a bleep should be heard. Then repeat
the lighting procedure.* see note on page 7
c. With the appliance lit, by pressing
thermostat setting and vice versa. When Room thermostat mode is active, the display shows the
set temperature value and the "AUTO" icon will appear on the LCD display. By using the
key the desired room temperature can be set. When manual mode is active, the display shows
the "MAN" icon plus the flame icon and a five level bar icon setting. By pressing the
the flame picture can be adjusted at five stages between high and low flame. If level 5 is currently
active, the icon max
d. To switch off the appliance press the
the appliance will bleep and then shut off.
e. The appliance can be switched off with out using the hand set by removing the appliance batteries
located below the air grill cover. When the batteries are removed there will be a delay (up
3minutes) after which, double bleeps may be heard and shortly after the appliance will extinguish.
Ensure that the battery is reconnected once the fire as been extinguished. The appliance cannot
be operated without the use of the handset.
Room Thermostat mode
The remote handset checks the room temperature at a fixed time intervals. Depending on the
difference between set room temperature and the actual room temperature the remote proceeds to
modulate in one level steps. Once the room temperature is reached it moves to standby position pilot
Only.
Introduction Continued
Operating the Appliance
button. Continue to
button for at least 2 seconds and
below the flame icon will appear.
key the operational mode is switched from manual to Room
button for at least 2 seconds and on releasing the button
5
arrow key,
LT6159 issue 7(06/13)
arrow