Motor Support Assembly; Rotisserie Kit Assembly - BBQ PC Signature Series Assembly Instructions Manual

Step 14 (Motor support assembly)
a) Take two pre-installed screws out
of motor support (AC).
b) Align the holes on the motor support
(AC) with the hole on the left side
wall of firebox.
c) Insert one M6 x 15mm bolt (AA),
one M6 flat washer (BB) and one
M6 spring washer (CC) and one
nut into each drilled hole and
tighten by screwdriver provided.
AD
AB
Z
V
X
W
Y
24
AC
Step 15 (Rotisserie kit assembly. Option)
a) Assemble the left shaft (AB) and right
shaft (V) by turning screwing them
together.
b) Insert two forks (Z), balance block (Y),
roller (X) and handle (W) into shaft
assembly as shown in above sequence.
Insert the left end of the shaft (AB) into
the slot on the motor (AD).
c) Place the assembled rotisserie kit on the
grill by sliding the motor into the motor
support and place the roller on the right
side wall of grill.