Advertisement
INCLUDED PARTS
Included parts are:
1. 3-3/4" Hex head bolts (4)
2. End caps (bolt covers) (8)
3. Flat washer (used to "shorten" bolt so end cap will fit on the nut) (4)
4. End cap washers (end caps snap onto them) (8)
5. 3/8" Locknut (4)
6. Cable (1)
7. Row handle (1)
8. Handle clip (1)
ASSEMBLING THE SU50
1. Line up the Weight Stack Subframe and the Seat Subframe sections. Line up the
boltholes in the two sections.
Figure 3. Lined up sections of the Seated Row SU50.
2. Insert the bolts with flat washers and end cap washers at the head. Slide the flat
head washers onto the four bolts and insert the bolts into the Seat Subframe section of
the SU50. The flat washers will "shorten" the bolt so that the end caps will fit onto the nut
end of the bolt. Figure 4 shows the inserted bolt from the Seat Subframe side of the
SU50.
Seated Row SU50 Customer Assembly Instructions
3
Advertisement
