Lcd Error Messages - MakerBot Replicator 2X User Manual

LCD ERROR MESSAGES

If your MakerBot Replicator 2X encounters problems during operation, the LCD menu will
display an error message. The following table describes each possible error message.
NOTE: If you see an error message in an unexpected context, submit a case to MakerBot
www.makerbot.com/support/submit-a-case/
Support at
Error Message
73 TROUBLESHOOTING
Description
Use the LCD menu to check your target
extruder temperatures. Navigate to Info
and Settings > Preheat Settings to make
sure the extruder temperatures are not
set higher than 300° C.
If the extruder temperatures are set to
below 300° C, visit
support/new/support
support options are.
To clear this message, you will have to
restart your MakerBot Replicator 2X.
Your MakerBot Replicator 2X has
automatically disabled its heaters after a
period of inactivity as a safety precaution.
Restart your print or the preheat routine to
reset your heaters.
makerbot.com/
to learn what your