Table of Contents
Advertisement
3
Troubleshooting: Keypad
A
The keypad is unresponsive.
Keypad error test
Install a fresh set of batteries and turn switch #3 to the ON position. Test
each button on the keypad (one at a time) and listen for a beep on each
button press. If beeping is not heard on all buttons, contact Technical
Support for further troubleshooting.
B
The Lock button does not lock the door.
No user codes are programmed.
If there are no codes in the lock, the lock button will not lock the door.
This is indicated by the keypad fl ashing red three times with three
beeps. Program at least one user code and test the Lock button again.
The battery is too low to lock the door.
This is indicated by the keypad fl ashing red three times with three beeps.
Remove the batteries and replace with a fresh set.
USA: 1-800-677-5625
Canada: 1-800-501-9471
www.weiserlock.com
Keypad lockout
If three incorrect codes were entered within one minute, the keypad will
lock for 60 seconds.
The set screw in the lever was not fully
tightened.
Fully tighten the pre-installed set screw at the bottom of the interior
lever.
7 / 9
62816 / 01
©2015 Spectrum Brands, Inc.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the SmrtCode 5 and is the answer not in the manual?
Questions and answers