About The Mastercode; Enabling And Setting The Mastercode; Master Code - Weiser SmrtCode 5 Programming And Troubleshooting Manual

1
Mastercode
A

About the Mastercode

Using a Mastercode is an optional, added-security measure. It is not enabled by default. A Mastercode is
used to add and delete user codes, but it cannot unlock the door (unless the same code is programmed
as a user code, though this is not recommended). The Mastercode must be 4-8 digits.
B

Enabling and Setting the Mastercode

Programming timeout: If no button is pressed for fi ve seconds, the system will time out
and you will need to restart the procedure.
1. Keep door open. Press and HOLD the Program button until the keypad
fl ashes green (about 5 seconds).
2. Enter new Mastercode.
3. Press Lock button once.
USA: 1-800-677-5625
Canada: 1-800-501-9471
www.weiserlock.com
4. Re-enter Mastercode.
5. Press Lock button once.
If programming is successful, the keypad will flash green once with
one beep.
If programming is unsuccessful, the keypad will fl ash red three times
with three beeps. Make sure the Mastercode has not already been
programmed. Attempt the procedure again, making sure to enter the
same new Mastercode in step 2 and 4.
6. Make sure switch #3 is on, and press the Program button once. If
you hear three beeps and see the keypad fl ash green three times, the
Mastercode is enabled.
Note: The lock will time out after fi ve seconds.
2 / 9
62816 / 01
©2015 Spectrum Brands, Inc.