Weiser SMARTCODE 10 Quick Start Manual

Hide thumbs Also See for SMARTCODE 10:

How to Perform the Door Handing Process

Install 4 AA batteries in battery pack.

Make sure the door is open and the latch is extended.

Press and hold the Lock button. Do not release.

Insert the battery pack and continue holding the Lock button.

The latch bolt will retract and extend to learn the locking and unlocking direction

of the door. Status LED will indicate success or failure.

Success: LED flashes green

Failure: LED remains solid red

Programming Video: https://www.youtube.com/watch?v=WZSMIYoiuhM&t=49s

THE LEADER IN RESIDENTIAL SECURITY

213826 10/17

Table of Contents

Do you have a question about the SMARTCODE 10 and is the answer not in the manual?

Page 1 How to Perform the Door Handing Process Install 4 AA batteries in battery pack. Make sure the door is open and the latch is extended. Press and hold the Lock button. Do not release. Insert the battery pack and continue holding the Lock button. The latch bolt will retract and extend to learn the locking and unlocking direction of the door.
Page 2 How to Add a Code: Use a phillips screwdriver to remove the 2 set screws on the interior of the lock. Remove cover and set aside. Make sure the door is open. Press the round program button that was under the cover you removed. Enter new user code.
Page 3 How to Remove a Code: Use a phillips screwdriver to remove the 2 set screws on the interior of the lock. Remove cover and set aside. Make sure the door is open. Press the round program button that was under the cover you removed. Press the “Lock”...