Wireless Remote (Machines With Electronic Hydraulic Controls) - Toro ProPass 200 Service Manual

Wireless Remote (Machines with Electronic Hydraulic Controls)

The wireless remote is a solid state electrical device that
sends radio frequency (RF) signal inputs to the machine
wireless remote base unit for control of machine electri-
cal operation. The wireless remote has sufficient range
to send an RF signal to the remote base unit from the tow
vehicle operator position.
The wireless remote uses two (2) LED's to indicate re-
mote operation. The green LED flashes when a base
unit signal is being sent to the remote. The green LED
will also illuminate when a remote button is pressed. The
amber LED flashes when a signal is being received from
the remote base unit. The amber LED will illuminate
when one or more base unit outputs are active.
Button Operation
NOTE: Refer to the Operator's Manual for detailed in-
formation on wireless remote operation.
Pressing the ON/OFF button turns the machine base
unit ON or OFF for ProPass operation.
The ALL START button is used to begin ProPass rear
option (twin spinner or conveyor) and floor operation.
Four (4) buttons are used to control the floor: start, stop,
increase floor speed and decrease floor speed.
Four (4) buttons are used to control the rear option (twin
spinner or conveyor): start, stop, increase rear option
speed and decrease rear option speed.
The ALL STOP button stops floor and rear option opera-
tion.
Four (4) buttons are used for preset programming for the
ProPass. Three (3) presets can be made to allow quick
option speed values for the floor and rear option. The
STORE button allows the presets to be adjusted.
Wireless Remote Batteries
The wireless remote is powered by four (4) AA alkaline
batteries. When the low battery power warning is dis-
played on the remote LCD display, the batteries should
be replaced. Remove battery cover on rear of remote
and replace batteries noting polarity marks in remote for
proper installation of batteries.
NOTE: Holding down the remote ALL STOP and OP-
TION STOP buttons simultaneously results in display of
battery life expectancy.
Electrical System
LCD Display
The wireless remote LCD display can be used to identify
activity between the remote and the base unit. LCD dis-
play messages are included on the following page.
1
2
3
4
5
6
7
8
9
1. LCD display
2. Controller status LED's
3. All start button
4. ON/OFF button
5. Store button
6. Preset 1 button
7. Preset 2 button
8. Preset 3 button
9. All stop button
1
2
1. Rear of remote
2. Battery cover
Page 4 - - 18
10
11
12
13
14
15
16
17
Figure 20
10. Floor start button
11. Floor stop button
12. Floor speed increase
13. Floor speed decrease
14. Option start button
15. Option stop button
16. Option speed increase
17. Option speed decrease
3
Figure 21
3. Battery location
ProPass 200