Floor Motor - Toro ProPass 200 Service Manual

Floor Motor

18
Loctite #242
Loctite #242
1. Drive chain
2. Hydraulic floor motor
3. Sprocket
4. Sprocket
5. Idler sprocket
6. Cap screw
Removal (Fig. 39)
1. Position machine on a level surface. If ProPass is at-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
Hydraulic System
15
3
15
Antiseize
Lubricant
7. Flat washer (2 used)
8. Lock nut
9. Cap screw (2 used)
10. Lock nut (2 used)
11. Cap screw
12. Flat washer
17
7
6
8
7
5
14
13
Direction
Of Rotation
Figure 39
2. Remove guards from frame to allow access to floor
motor (see Bed Guards in the Service and Repairs sec-
tion of Chapter 5 -- Chassis).
3. Loosen cap screw and lock nut that secure idler
sprocket to frame. Move idler sprocket to remove ten-
sion from drive chain.
Page 3 - - 38
Loctite #242
9
15
11
12
10
1
16
FRONT
RIGHT
13. Square key
14. Spacer
15. Set screw (2 used per sprocket)
16. Master link
17. Woodruff key
18. Drive roller shaft
4
15
2
Antiseize
Lubricant
ProPass 200