Pendant Assembly (Machines With Standard Hydraulic Controls) - Toro ProPass 200 Service Manual

Pendant Assembly (Machines with Standard Hydraulic Controls)

The pendant assembly allows the machine operator to
engage the rear option (twin spinner or conveyor) and
the floor from the tow vehicle operator's position. The
pendant assembly includes two (2) switches, the junc-
tion box and the wire harness (Fig. 17).
Both of the switches used in the ProPass pendant are
two (2) position switches with two (2) terminals. To ac-
cess the switch terminals for testing, remove the cover
from the bottom of the junction box. Make sure that elec-
trical power to the switches is disconnected before test-
ing the switches. Use a multimeter to check the switch
for continuity. There should not be continuity between
the switch terminals when the switch is in the OFF posi-
tion as shown in Figure 17. There should be continuity
between the switch terminals when the switch is in the
ON position.
If switch testing determines that a switch is faulty, re-
move switch from junction box and replace switch (Fig.
18). Make sure that wire harness connectors are at-
tached to correct switch terminals (Fig. 19).
ProPass 200
1
2
3
1. Rear option switch
2. Floor switch
7
1. Rear option switch
2. Floor switch
3. Junction box
4. Switch guard
TOP VIEW OF SWITCHES
WHITE
WIRE
1
BLACK
WIRE
POSITION
1. Spinner switch
Page 4 - - 17
4
Figure 17
3. Junction box
4. Wire harness
6
5
4
3
2
1
Figure 18
5. Pop rivet (2 used)
6. Switch boot (2 used)
7. Washer
8. Wire harness
WHITE
WIRE
OFF
POSITION
OFF
2
GREEN
WIRE
Figure 19
2. Floor switch
Electrical System
8