Toro ProPass 200 Service Manual page 75

Problem
Rear option does not function (machines with
electronic hydraulics).
NOTE: Start button on remote must be pushed twice to
activate rear option. Also, check wireless remote LCD
display and base unit LED's for help in troubleshooting.
Floor does not function (machines with standard
hydraulics).
Floor does not function (machines with electronic
hydraulics).
NOTE: Check wireless remote LCD display and base
unit LED's for help in troubleshooting.
ProPass 200
Possible Causes
Wireless remote has not been turned ON.
Wireless remote has timed out due to thirty (30)
minutes of inactivity.
Wireless remote settings are incorrect.
Proportional flow valve coil (PV1) or circuit wiring is
faulty.
Hydraulic problem exists (see Chapter 3 -- Hydraulic
System).
Wireless remote is faulty.
Base unit is faulty.
Floor switch in pendant is OFF.
Floor switch in pendant is faulty.
Floor solenoid valve coil or circuit wiring is faulty.
Hydraulic problem exists (see Chapter 3 -- Hydraulic
System).
Wireless remote has not been turned ON.
Make sure that floor start--up procedure has been
correctly completed with remote.
Wireless remote has timed out due to thirty (30)
minutes of inactivity.
Wireless remote settings are incorrect.
Proportional solenoid valve coil (SP1) or circuit wiring
is faulty.
Hydraulic problem exists (see Chapter 3 -- Hydraulic
System).
Wireless remote is faulty.
Base unit is faulty.
Page 4 - - 15 Electrical System