Information; Power Pack Hydraulic Tank - Toro ProPass 200 Service Manual

Power Pack Hydraulic Tank

RIGHT
FRONT
14
16
17
15
1. Hydraulic relief valve manifold
2. Flange nut (9 used)
3. Flange head screw (4 used)
4. Hydraulic tank assembly
5. Hose bracket
6. R- -clamp (3 used)
7. R- -clamp (3 used)
o
8. 45 hydraulic fitting (2 used)
Removal (Fig. 7)
1. Position machine on a level surface. If ProPass is at-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components in the Service
and Repairs section of Chapter 3 -- Hydraulic System.
Hydraulic Power Pack
19
22
18
1
2
9. Hydraulic hose
10. Filter head
11. Hydraulic hose
12. Flange nut (4 used)
13. Oil filter
14. Cap screw (2 used)
15. Straight hydraulic fitting
5
2
22
11
6
7
2
8
10
13
8
Figure 7
Before disconnecting any hydraulic compo-
nents, operate all hydraulic controls to relieve
system pressure and avoid injury from pressur-
ized hydraulic oil. See Relieving Hydraulic Sys-
tem Pressure in the General Information section
of Chapter 3 - - Hydraulic System.
Page 6 - - 14
22
4
2
9
12
16. Hydraulic gear pump
17. Straight hydraulic fitting
18. Battery tray
19. Battery
20. O- -ring
21. #6 plug
22. Flange head screw (7 used)
CAUTION
3
20
21
ProPass 200