Operation - Gardena TCS 720/20 Operation Instructions Manual

To fill in chain oil:
0
q
w
To check the oil lubrication
system:

4. OPERATION

2 3 1
To connect the pruner:
z
r
DANGER!
Physical injury due to chain breakage when the chain
on the bar is not sufficiently lubricated.
v Check whether sufficient quantities of chain oil are
delivered prior to each use.
We recommend to use Art. 6006 GARDENA Oil or an equivalent
mineral chain oil from a specialist supplier.
1. Unscrew the lid of the oil tank
2. Fill the chain oil into the filler neck
is fully filled with oil.
3. Close the lid of the oil tank
The unit must be cleaned thoroughly if oil has been spilled.
v Point the bar
approx. 20 cm. After operating the unit for one minute, clear traces
of oil must be visible on the surface.
Never let the bar come into contact with sand or soil as this
will lead to increased wear of the chain.
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
v Before you connect, adjust or transport the unit,
disconnect the mains cable and slide the protective
cover
1
DANGER! Risk of electric shock!
To avoid damage to the mains cable
cable
v Before you operate the unit insert the extension cable
into the cable lock
v Never take hold of the protective cover
t
ing the unit.
l
1. Loop the extension cable
k
and pull tight.
2. Connect the plug
cable.
3. Connect the extension cable
.
0
again.
0
at a bright wood cutting surface at a distance of
2
over the bar and close the snap fit
2
must be inserted into the cable lock
t
.
z
, insert the loop into the cable lock
t
of the unit into the socket
k
into a 230 V mains socket.
t
until the viewing window
q
.
3
the extension
r
z
when connect-
1
of the extension
l
w
.
t
z
7