Cisco SVP2000P User Manual page 25

Field name
Choose line to set info about SIP, there are 3 lines to choose. You can switch by
Register Status
Server Name
Server Address
Server Port
Account Name
Password
Phone Number
Display Name
Proxy Server Address
Proxy Server Port
Proxy Username
Proxy Password
Domain Realm
Enable Register
Register Expire Time
NAT Keep Alive Interval
User Agent
Signal Key
Media Key
Local port
Ring type
Hot line Number
Conference Number
Transfer Expire Time
Enable subscribe
Enable Keep
Authentication
NAT Keep Alive
S T E P H E N T E C H N O L O G I E S C O . , L I M I T E D
T e l : + 8 6 7 5 5 8 9 3 5 2 6 0 6 / F a x : + 8 6 7 5 5 8 9 3 5 2 6 1 2 / E m a i l : S u p p o r t @ s t e p h e n - t e l e . c o m / U r l : w w w . s t e p h e n - t e l e . c o m
Shows if the phone has been registered the SIP server or not; or so, show Unapplied;
Set the server name.
Input your SIP server address.
Set your SIP server port.
Input your SIP register account name.
Input your SIP register password.
Input the phone number assigned by your VoIP service provider. Phone will not register if
there is no phone number configured.
Set the display name.
Set proxy server IP address
Server. But if your VoIP service provider give different configurations between Register SIP
Server and Proxy SIP Server, you need make different settings.)
Set your Proxy SIP server port.
Input your Proxy SIP server account.
Input your Proxy SIP server password.
Set the sip domain if needed, otherwise this VoIP phone will use the Register server address
as sip domain automatically. (Usually it is same with registered server and proxy server IP
address).
Start to register or not by selecting it or not.
Set expire time of SIP server register, default is 60 seconds. If the register time of the server
requested is longer or shorter than the expire time set, the phone will change automatically
the time into the time recommended by the server, and register again.
Set examining interval of the server, default is 60 seconds
Set the user agent if have, the default is VoIP Phone 1.0
Set the key for signal encryption
Set the key for RTP encryption
Set sip port of each line
Set ring type of each line
Set hot line number of each line
Configure conference number in server conference.
For the phone supports the transfer of certain special features server, set interval time
between sending "bye" and hanging up after the phone transfers a call.
Enable the option ,the phone will receive the notify from the server.
Enable/Disable Keep Authentication System will take the last authentication field which is
passed the authentication by server to the request packet. It will decrease the server's
repeat authorization work, if it is enable.
Enable/Disable keeps NAT of SIP alive.
If some server refuse to register with too short interval time, and has no packets sending to
device in private network to keep NAT alive, user could set this function ON. It need set the
keep alive interval time less than the NAT server's.
/ 5 / F , B u i l d i n g N O . 1 , T o n g X i n I n d u s t r y Z o n e , H e n g G a n g , L o n g G a n g , S h e n z h e n , G . D , C h i n a , 5 1 8 1 1 5
S V P 2 0 0 0 P P B u s i n e s s P O E I P P h o n e U s e r M a n u a l
SIP Config
explanation
（ U sually, Register SIP Server configuration is the same as Proxy SIP
【 【 【 【 L oad 】 】 】 】 button.
- 2 5 -