Grandstream Networks GXP1610 Administration Manual page 29

Settings -> Call Features
Off-hook Auto Dial
Off-hook Timeout
Intercom User ID
Disable Call Waiting
Disable Call Waiting
Tone
Disable Direct IP Call
Use Quick IP Call mode
Disable Conference
Disable in-call DTMF
Display
Enable Sending DTMF
via specific MPKs
Mute Key Functions
While Idle
Disable Transfer
In-call dial number on
pressing transfer key
Auto-Attended Transfer
Do Not Escape #
as %23 in SIP URI
Click-To-Dial Feature
Call History Flash
Writing:
Write Timeout
Call History Flash
Writing:
Max Unsaved Log
Settings ->Multicast paging
Paging Barge
Paging Priority Active
Note:
When the phone is in public mode login screen, press CONF button will have
the IP address of the phone displayed.
Configures a User ID/extension to dial automatically when the phone is
offhook. The phone will use the first account to dial out. The default setting is
"No".
If configured, when the phone is onhook, it will go offhook after the timeout (in
seconds). The default value is 30 seconds.
Configures the intercom extension number for account 1 to dial out. This User
ID is mapped to the INTERCOM button on the phone.
Disables the call waiting feature. The default setting is "No".
Disables the call waiting tone when call waiting is on. The default setting is
"No".
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same LAN/VPN
segment by entering the last octet in the IP address. To dial quick IP call,
offhook the phone and dial #XXX (X is 0-9 and XXX <=255), phone will make
direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP
address REGARDLESS of subnet mask. #XX or #X are also valid so leading
0 is not required (but OK). No SIP server is required to make quick IP call.
The default setting is "No".
Disables the Conference function. The default setting is "No".
When it's set to "Yes", the DTMF digits entered during the call will not display.
The default setting is "No".
Allows certain MPKs to send DTMF in-call. This option does not affect Dial
DTMF.
When set to "DND", the DND will be enabled for future incoming call if
pressing MUTE key in idle state; If this feature is set to "Idle Mute", MUTE key
will take effect in idle state and future incoming call will be answered with
mute; Otherwise, MUTE key will not take effect in idle state.
Disables the Transfer function. The default setting is "No".
Configures the number for the phone to dial as DTMF during the call using
TRAN button.
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Specifies whether to replace # by %23or not for some special situations. The
default setting is "No".
Enables Click-To-Dial feature. The default setting is "Disabled".
Defines the interval (in seconds) to save the call history to phone's flash. The
default value is 300 seconds.
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
During active call if incoming multicast page's priority is higher than this value,
the call will be held and multicast page will be played.
If enabled, during a multicast page if another rmulticast is received with higher
GXP1610/GXP1620/GXP1625/GXP1628
Administration Guide
Page 28 of 48