Advertisement
FIGURE 6
6
20
19
TIGHTEN!
26
1A
8
24
STEP 6:
• SECURELY assemble the GUIDE ROD SUPPORT (6) to the TOWER (1) and MAIN UPRIGHT (2) using four RH CAPS (27), two
3/8 X 2-3/4" BOLTS (9), four 3/8" RH WASHERS (14) and two 3/8" LOW HEIGHT LOCK NUTS (11) as shown in FIGURE 6.
• Slide GUIDE ROD BUSHINGS (20) into the tubes on the GUIDE ROD SUPPORT (6), slide 1" SHAFT COLLARS (19) under-
neath the GUIDE ROD BUSHINGS (20) and SECURELY tighten the set screws.
• Insert the WEIGHT STACK PIN (15) into the WEIGHT STACK as shown in FIGURE 6.
• Screw the treaded end of the CABLE all way into the end of the shaft on the HEAD PLATE (8) and tighten jam nut securely. See
FIGURE 6.
11
9
1
14
2
15
9 3/8 X 2-3/4"
27
Advertisement
