Troubleshoot With The Leds - NETGEAR C6300BD User Manual

Table 4. Quick tips for troubleshooting
Problem
All LEDs stay on.
Ethernet LED is off for a port
with an Ethernet connection.
Internet LED (or, for model
AC1900, the Online LED) is
off even though the cable data
gateway is connected to the
cable wall jack.

Troubleshoot with the LEDs

When you turn on the power, the LEDs light as described here.
1. When power is first applied, all LEDs light solid.
Whether an Ethernet LED lights depends on whether an Ethernet device is connected to
the cable data gateway.
2. After approximately 12 seconds, all LEDs start blinking green except for the Power LED,
which blinks red.
3. After approximately one minute, the following LED behavior occurs:
• The Power LED turns solid green, indicating that the boot process is complete.
• The Downstream LED starts blinking green.
• The 2.4 GHz and 5 GHz LEDs (or, for model N450, the WiFi LED) start blinking green
or light solid green.
4. After the cable data gateway establishes a downstream connection, the following LED
behavior occurs:
• The Downstream LED lights solid blue or green.
• The Upstream LED starts blinking green.
5. After the cable data gateway establishes an upstream connection, the Upstream LED
lights solid blue or green.
AC1900, N900, and N450 WiFi Cable Data Gateways
Possible Solution
• Clear the configuration of the cable data gateway to its factory defaults.
This operation sets the IP address of the cable data gateway to
192.168.0.1.
• If the error persists, it is possible that a hardware problem occurred.
Contact Cox Support.
• Make sure that the connected Ethernet device does not use a static IP
address but is configured to receive an IP address automatically with
DHCP.
• Make sure that the Ethernet cable connections are secure at the cable data
gateway and at the Ethernet device.
• Make sure that power is turned on to the connected Ethernet device.
• Be sure that you are using the correct cable.
• Make sure that the coaxial cable connections are secure at the cable data
gateway and at the wall jack.
• Make sure that your cable service provider provisioned your cable Internet
service. Your provider can verify that the signal quality is good enough for
cable data gateway service.
• Remove any excessive splitters that you installed on your cable line. Run a
"home run" back to the point where the cable enters your home.
Diagnostics and Troubleshooting
155