Table Of Contents - Honeywell evohome Installation Manual

Hide thumbs Also See for evohome:

Table of Contents

P13

Step 3: Power up and

bind devices

If you bought a Base Pack or a Connected Pack only - your devices are

already bound. Go to Step 4.

If you bought an unbound Central Controller, plus other devices and

are using 'Guided Configuration' follow the instructions on your Central

Controller screen and use this section to put the devices into binding mode.

If you bought a Base Pack or a Mobile Connected Pack, plus other devices,

you need to power up all devices and then bind them to the Central

Controller using the 'Installation Menu'. It may be easier to power up and

bind some devices while they're close to the Central Controller - you can

install them in their assigned zones later.

Follow the instructions for the device(s) you're going to bind. When you

bind a device to the Central Controller the devices permanently store the

connection and there should never be a need to rebind them even after a

power cut.

In this section

evohome Installation Guide

Show Quick Links

Table of Contents