Honeywell evohome Installation Manual page 12

P10
Powering up your Central Controller
!
Your Central Controller
comes with *rechargeable
batteries which are
pre-charged allowing
you to set-up the system
while off the table stand
or wall bracket.
Place the Central Controller
on the table stand or wall
bracket for normal use.
*Only use the
AA rechargeable
batteries provided
Step 2: Set up evotouch
First, power up the Central Controller
Remove the cover, remove the battery
1
tab and replace the cover
Place it on the table stand or wall bracket
2
Once the batteries are fully charged, the Central
3
Controller can be easily removed from the table stand or
wall bracket for ease of programming. After 30 minutes
the Central Controller will emit a beep to indicate that
it should be replaced on the stand or wall bracket
1
PUll TAB