Fuel System; Battery Requirements; Battery Charging; Model And Serial Number - Champion 100199 Operator's Manual

FUEL SYSTEM

The engine is fitted with a dual master mixer assembly
carburetion system, which allows it to run on either NG or
LPG. It has been configured at the factory to run on NG. If your
installation requires the engine to run on LPG, orifices in the
master mixer assembly carburetor must be changed.

BATTERY REQUIREMENTS

Champion requires two (2) 12 volt batteries with a minimum of
18 Ah with a minimum of 270 CCA each. [battery size: 6-7/8
L x 3-7/16 W x 6-1/8 H inches (175 mm L x 87 mm W x 155
mm H)]. Purchase the batteries locally. Install the positive battery
cable first.
Install a cable from the positive (+) terminal of one battery to the
negative (–) terminal of the other battery. Always connect the
positive (+) battery cable to the generator first. (Figure 8)
2
To Ground
!
For battery installation, maintenance, and safety
requirements refer to purchased manufacturer battery
installation and safety manual.
© 2015 Champion Power Equipment
1
Figure 8
CAUTION
GENERAL INFORMATION

BATTERY CHARGING

The generator is equipped with an automatic battery charger. The
charger will sense the battery's state of charge and automatically
charge the battery when required. LED lights on the charger display
the battery state of charge. See Figure 7 on page 17.

MODEL AND SERIAL NUMBER

The model and serial number plate is affixed to the generator
above the control panel. Have this information if calling for
service or ordering parts. (Figure 9)
To Starter
Model 100199
Figure 9
Part No. 101048
19