Introduction; The Access Levels; User Level - Faraday MPC-6000 Programming Manual

Introduction

The MPC 6000/7000 Fire Alarm Control Panels are completely field programmable.
Although programming requires no special software skills, a thorough working
knowledge of Fire Alarm Control Panels and devices is assumed. There are two
ways to program an MPC 6000/7000 fire alarm system control unit:
1. Auto Program. Using Auto Program will quickly configure the FACP in a General
Alarm configuration.
2. Manual Program. Editing the program manually using the keypad.
Both methods require that the Technician password be entered so that the
Technician functions may be accessed. Jump to the Quick Start section if you need
to get a system up and running quickly.

The Access levels

The MPC 6000/7000 system has three functional levels as follows:
•
User Level, no password is required to access these functions.
•
Maintenance Level, accessed using the Maintenance password, allows access to the
maintenance menu functions.
•
Technician Level, accessed using the Technician password, allows access to trained
technician menu functions.

User Level

The User level functions accessible to the system user are protected from
unauthorized use by the lock on the front of the cabinet. Pressing the Menu button
on the lower right of the operator interface accesses the user functions. The
functions available to the User are as follows:
•
Activate a General Alarm
•
Activate an Alert event
•
Activate a Recall event
•
Activate a Lamp Test
•
Activate a Drill
•
View event history
•
Go to Maintenance Level (with the password)
•
Go to Technician Level (with the password)
•
Log on to a remote panel
M P C 6 0 0 0 / 7 0 0 0
1
P R O G R A M M I N G M A N U A L