Faraday MPC-6000 Programming Manual page 12

M P C 6 0 0 0 / 7 0 0 0
5 Notifications
appliance circuits
Optional 6 LCD Annunciators
Optional 7 Remote LEDs
Optional 8 Remote Relays
Optional 9 DACT line/DACT
account
10 Validate
11 Activate
P R O G R A M M I N G M A N U A L
Configure the behavior of the NACs and the
output zone that will activate each NAC. Note
that a NAC must be configured as connected to
an output zone or it will not activate.
If there are any remote LCD displays, set
whether installed.
If there are any remote LED modules, configure
each of the remote LEDs. Select the Output
zone that will activate the LED.
If there are any remote Relay modules,
configure each of the remote Relays. Note that
the Relays must be connected to an Output
Zone in order to activate.
If a dialer is installed, configure the line and
account data.
Run the validate and fix any errors that are
reported.
Swap the backup configuration with the primary
configuration.
8