Fire Sense LIP-10A-TGG-LPG-BU User Manual page 9

ASSEMBLY
4
4. Place Tank Housing (C) onto Base (I). Slide Tank Housing (C) over
the Post and down over the Post Supports.
Rest Tank Housing on Base.
5. Attach Head Assembly (B) to Post (F).
Note: There is a small piece of protective foam located in the
neck of the Head Assembly that MUST be removed prior to
attaching Head Assembly to the Upper Post. 5
Route Gas Hose (D) down into Post and align 4 small holes on
Head Assembly with 4 Small holes in Post (F).
[HINT: Control knob should be above decal on post.]
Insert 4 M6x10 (EE) bolts through 4 M6 lock washers into holes
and tighten.
Hardware Used: 4 x EE, Bolt M6x10 and Lock Washer M6
6-1. FOR ITEM 61436
Assemble Reflector Panels (A) with Reflector Center Cap. Reflector
Panels (A) come packaged in two brown boxes with two panels in each
box. Hardware for assembly is already affixed to each panel. Place two
panels side by side and remove the two cap nuts and washers that are
affixed to one panel. Insert the affixed bolts into the open holes on the
adjacent panel. Place the washer over the bolt and screw on cap nut.
Repeat these steps until all four panels are assembled. Then locate
the Reflector Center Cap. You will need to remove the cap nuts and
washers located at the top of each Reflector Panel to allow assembly
of the Center Cap on each panel. Align the holes in the Center Cap
with the bolts on each panel and affix washer and cap nut to
complete assembly.
6-1
9