Fire Sense LIP-10A-TGG-LPG-BU User Manual page 8

ASSEMBLY
2. Attach the Post Supports (H) to the Base (I). Align the holes in the
2
bottom of each Post Support with the hole on the Base.
Insert 1 M8x16 (AA) bolt through the hole in the support and into the
Base and hand tighten. Repeat with the other 2 Post Supports and
then tighten all bolts with a wrench.
Hardware Used: 3 x AA, Bolt M8x16
Attach the Post (F) to the Post Supports (H). Once you
3.
have tightened the bolts holding the Post Supports (H) to the Base (I),
align the holes in the Post (F) with the holes on the tops
3
of the Post Supports (H) and insert a M6x35 (CC) bolt through a M6 (HH)
washer and then through the hole in the Post Support. Affix another
M6 (HH) washer onto the bottom of the M6x35 (CC) bolt and secure with a
M6 (DD) nut. Repeat this in the 5 remaining holes (6 holes total—2 for
each Post Support piece). Hand tighten initially then tighten with a
wrench when all bolts have been inserted.
Hardware Used: 6 x CC, Bolt M6x35
12 x HH, Washer M6
6 x DD, Nut M6
8