Brake Fluid Level Check - VESPA GTS Super 125 i.e. (2009) Service Manual

Braking system
N.B.
DURING THE BLEEDING OPERATIONS, MAKE SURE THE BRAKE FLUID DOES NOT COME INTO
CONTACT WITH THE BODYWORK SO AS NOT TO DAMAGE IT. FURTHERMORE, DURING THE
BLEEDING OPERATIONS REGARDING THE BRAKE CALLIPERS, MAKE SURE THE BRAKE
FLUID DOES NOT COME INTO CONTACT WITH THE DISC BRAKES AND WITH THE BRAKE
PADS. FAILURE TO OBSERVE THIS PRECAUTION WILL ENDANGER THE PROPER WORKING
AND EFFICIENCY OF THE BRAKING SYSTEM
Specific tooling
020329Y Mity-Vac vacuum-operated pump
Locking torques (N*m)
System bleed calliper fitting: 12 ÷ 16 Nm

Brake fluid level check

- Position the vehicle on a flat surface and on the
centre stand
- Remove the brake pump cover as indicated in the
photo
- Use the appropriate spyglass on the pump to check the level of the brake fluid, as shown in the
photograph
- If the level is below the minimum, fill up by acting
on the two screws shown in the figure.
- Remove the gasket and fill with recommended
brake fluid until the spyglass is completely cov-
ered.
CAUTION
BRAK SYS - 170
Vespa GTS Super 125 i.e. (2009)