Table of Contents
Advertisement
MD Data
Automatic
Routing Mode
Manual
Multidest
(Selectable in
Device Limit
multiples of 8)
Default Name
System Name
Set
a. See
Defaults
on page 81.
Checkbox Options
The checkbox options section is just below the panel options section, enclosed in the same
box.:
A check in the box enables the option. Clearing the checkbox disables the option.
If a machine control (i.e., data) level is involved in a route, the sys-
tem makes the route on the control level even if the control port is
in use on the source or destination device. It breaks the previous
control connection and then makes a new control connection for
the route in progress.
If the control port is in use for the source or destination device, the
system takes all (selected) levels except control. It does not per-
form the control level route.
If the control port is not in use, the control level take occurs nor-
mally.
To carry out a take on a machine control port that is in use, the
operator must first free the port by performing a "tristate" take on
the port, that is, taking the device (as a source) to itself (as a desti-
nation) on the control level.
An operator can determine whether the control level is free by
switching momentarily to X-Y mode and examining the destina-
tion's levels on selection buttons.
The number of multi-destination entries you are defining. (Strictly
speaking, this is not a limit, but a count.) The default, and lowest
value, is 8. The maximum is 512. (If you have more entries than
devices, you can leave some MD destinations unassigned.)
A list of "name sets" appears in the drop-down menu. The name
sets can be defined under the System Management pane of
NV9000-SE Utilities. Choose 'System Name' in this list if you do not
want, or do not care about, device name aliases. Do not choose
'System Name' if you are configuring any 'Name Set Toggle' but-
tons.
NV9641A
User's Guide
21
Advertisement
Table of Contents
