Programming Ace Keyfobs Onto Your System - GARDINER TECHNOLOGY GARDTEC 590 User Instructions

User Manual
Programming ACE
Keyfobs onto your System
Two modes are available for ACE, these are 'Normal' & 'High' Security. Please check
the User Information Chart on page 2 noting the mode of your ACE control.
Normal Security
In this mode up to fourteen keyfobs may be programmed onto a single user number
1) Follow the procedure for programming user codes to the point when the user
code is entered.
2) Point the keyfob at the ACE unit and press the button on the fob.
3) Repeat this procedure for any other fobs you wish to be programmed using
the same user number each time (e.g User 1 or User 2 etc.) each time.
4) If more than one ACE receiver is fitted fobs need to be programmed onto all
ACE receivers, yet again the same user number should be used.
Note: When programming the fob onto more than one receiver (on the same
system) the button on the fob MUST be held down continuously
between programming onto the first and subsequent ACE receivers.
High Security
In this mode each keyfob will occupy a User number. The number of keyfobs that may
be used is limited by the maximum number of user codes available on the system up
to a maximum of fourteen.
1) Follow the procedure for programming user codes to the point when the user
code is entered.
2) Point the keyfob at the ACE unit and press the button on the fob.
3) Repeat this procedure for any other fobs you wish to be programmed using
a different user number each time (e.g User 1 or User 2 etc.) each time.
4) If more than one ACE receiver is fitted fobs need to be programmed onto all
ACE receivers, retaining the same user number for each individual fob.
Note: When programming the fob onto more than one receiver (on the same
system) the button on the fob MUST be held down continuously
between programming onto the first and other ACE receivers.
Note: In all cases when the ACE is used only Master & Main user levels will
allow part setting via the keyfob. Other code levels will only allow part
setting in conjunction with the keypad.
Page
26
GARDTEC 590/591