Resetting After Mains Failure; Using Led Keypads; Setting The System - GARDINER TECHNOLOGY GARDTEC 590 User Instructions

GARDTEC 590/591
4) To reset the system with an anti-Code, contact
the central station or engineer (as instructed by
the installation company) and quote the source
given by the display.
5) The central station or engineer will give a return
Anti-Code ( this may contain the YES & NO keys)
for example 5, YES, 2, 4.
6) Enter this Anti-Code into the keypad
7) The system is now reset.

Resetting After Mains Failure

After a mains failure the user will have to enter his/her code twice in order to operate
the system.
This section is dedicated to using LED keypads (Twin Seven Segment).

Setting The System

With the display showing U N
1)
2) Enter the User Code (followed by YES if Master or Main type code has been
used).
The display will show E = and the exit tone will sound. Exit the premises via
3)
the authorised exit route (the exit tone will change if any detectors are
violated during exit).
4) Once the premises are secure listen that the exit tone returns to the
continuous tone.
5) Wait until the exit tone finishes before leaving.

Using LED Keypads

Page
13
User Manual