Resetting After An Alarm; Resetting After Mains Failure - GARDINER TECHNOLOGY GARDTEC 590 User Instructions

User Manual

Resetting After An Alarm

Your installation company will have programmed the reset modes for your system so
that it complies to your insurance company and legislation requirements.
Your installation company will have informed you as to the type of reset that your
system is set for.
Before attempting to reset your system ensure that the system is Un-set.
1) If the system is programmed for any code reset enter a user (followed by YES
if Master or Main code is used), the exit tone will sound and the display will
show for example E $
2) Enter the code again to abort the setting.
3) The system is now reset.
Or
If the display shows ' Er ' when you attempt to reset it refer to the
programmed reset mode and take the appropriate action as follows:-
Reset Type
Master Code
Engineer Code
Engineer + Anti-Code
Anti-Code
4) To reset the system with an Anti-Code enter the number given by the central
station or installation company into the keypad (this may contain the YES &
NO keys).
5) The system is now reset.

Resetting After Mains Failure

After a mains failure the user will have to enter his/her code twice in order to operate
the system.
Action
Use a Master code to set and abort setting
Call the installation company.
Call the installation company.
When you try to set the system make a note of
the four digit number given on the display,
call the installation company or central station for
an Anti-Code and proceed as shown from step 4
Page
20
GARDTEC 590/591