Using The Wireless Controller - Canon optura300 Instruction Manual

Using the Wireless Controller
You can operate the camcorder with the ,
supplied wireless controller from a distance of
up to 16 feet (5 m). Point it at the camcorder's
remote sensor when you press the buttons.
Following functions cannot be operated
without the wireless controller:
• Some special playback modes (OJ 37)
• Photo/date search (CO 85)
• Zero set memory (CO 86)
• AV Insert (OJ 94)
• Audio dubbing (OJ 96)
• 12 bit audio out/mix balance (CO 98)
a
Camcorder and wireless controller are equipped with 2 remote sensor modes
(CO 48). If the wireless controller does not work, check if camcorder and
wireless controller are set to the same mode.
a
The wireless controller may not work properly in bright places, such as
outdoors under direct sunlight, or when used too close to the camcorder.
a
The operable range' of the wireless controller may shorten when the
camcorder's remote sensor is exposed to strong light.
a
When the batteries run out, replace both at the same time.
ls1seA1ig~Iw&WA~!!ii'#.J!ji_?i]i1!1iWf&:n:'iwmlmtE8iW.i:WmfM0mlJtiIW;ffM,;w:rililiif:iE8@jIW@ili~K111WiliWmttWWV4W@WIWWntmwmwmt:1lWWMWit%immn,iHf:1,f1MIXnSdf:1tiJ
The wireless controller operates with two AA batteries.
-
1. Open the battery cover.
2. Insert the batteries following the
+
and - markings.
3. Close the battery cover.
23