Canon optura300 Instruction Manual page 148

-
- l:
~ .9
o ...
•- ttl
.~
E
't:l ...
't:l
0
cs:~
.=
148
List of Messages
Message
Explanation
OJ
SET THE TIME ZONE,
You have not set the time zone, date and time. This message
24
DATE AND TIME
appears each time you turn the power on until you set the
time zone, date and time.
CHANGE THE
Battery pack is exhausted. Replace or charge the battery
16
SATTERY PACK
pack.
THE TAPE IS SET FOR
Cassette is protected. Replace the cassette or change the 22
ERASURE PREVENTION position of the protect switch.
REMOVE THE
Camcorder stopped operating to protect the tape. Unload
21
CASSETTE
and reload the cassette.
CHECK THE DV INPUT
DV cable is not connected, or the connected digital device is
90
turned off.
CONDENSATION HAS
Condensation has been detected in the camcorder.
152
BEEN DETECTED
TAPE END
Tape reached the end. Rewind the tape or replace the
21
cassette.
CHECK THE CASSETTE You attempted to perform audio dubbing or AV insert on a 94
[REC MODE]
tape recorded in a mode other than the SP mode. 96
CHECK THE CASSETTE
You attempted to perform audio dubbing on a tape
96
[AUDIO MODE]
recorded in 16-bit or 12-bit 4-channel sound.
CHECK THE CASSETTE
You attempted to perform audio dubbing or AV insert on a
94
[BLANK}
tape with a blank section.
96
HEADS DIRTY, USE Video heads are dirty. Clean the video heads.
152
CLEANING CASSETTE
COPYRIGHT PROTECTED
You attempted to play back a copyright protected tape.
91
PLAYBACK IS RESTRICTED
COPYRIGHT
You attempted to dub a copyright protected tape. May also
91
PROTECTED DUBBING appear when an anomalous signal is received during analog
RESTRICTED
line-in recording, or during analog-digital conversion of a
copyright protected tape.