Adding User Codes With The Master Code Enabled - Kwikset Smartcode 914 Programming And Troubleshooting Manual

C

Adding User Codes with the Master Code Enabled

The procedure for adding user codes is different when the Master Code is enabled. For instuctions on
how to add user codes when the Master Code is disabled, see the Installation and User Guide that came
with your lock.
1. Press the Program button once. The keypad will flash green and you
will hear three beeps.
2. Enter Master Code.
3. Press Lock button once.
Technical Support
1-866-863-6584
4. Enter new user code.
5. Press Lock button once.
If programming is successful, the keypad will flash green once with
one beep.
If programming is unsuccessful, the keypad will flash red three times with
three beeps. Make sure the user code is not a duplicate and that it is
between 4 and 8 digits during your next attempt. Make sure the lock has
room for an additional code. If all user codes are filled, delete a code to make
room for this one. Make sure to enter a valid Master Code in step 2.
6. While the door is open, test the user code to make sure it unlocks
the door.
3 / 13
61883 / 01
©2014 Kwikset Corporation