Table of Contents
Advertisement
ORDER DIRECTLY TODAY AT:
Gel frames and accessories
The MultiPAR does not use gel frame clips. However, both sides of the fixtures have
a bent sheet metal retainer to hold the gel frames in place. One side of the fixture
has a piece of spring steel that serves as a gel frame spring. The spring steel
pushes the gel frame into the MultiPAR. ETC identifies the side of the MultiPAR that
holds the gel frame as the gel frame retaining channel.
N o t e :
Use only color frames or accessories with 6.7" inside
diameter.
Insert the colorframe or accessory by pressing it against the spring.
1.
Once the edge of the frame has cleared the retaining channel, allow the edge of
2.
the frame to spring into the channel, thereby securing it.
Make certain the color frame is secured in the MultiPar opening by the spring clip
3.
before operating.
Cleaning the reflector
Unplug the fixture before attempting to clean the reflector.
1.
Remove the lamp before attempting to clean the reflector.
2.
Remove the lens so you can access the reflector from the front of the fixture. See
3.
on page 4.
Removing a lens
Remove dust with a blast of oil free air, or wipe with a clean, soft, lint-free cotton
4.
cloth. If this is sufficient to remove dust, go to step 7. Otherwise, continue to step
5.
Dampen a clean, soft, lint-free cotton cloth with a mild, soapy water solution and
5.
gently wipe the reflector.
Remove any soapy water residue with a clean, soft, lint-free cotton cloth
6.
dampened with water.
Reinstall a lens before using the fixture.
7.
C A U T I O N :
Do not use glass or window cleaners on the reflector.
Chemicals in the cleaners will harm the reflective
coating. Do not use paper towels or harsh materials to
wipe the reflector. These materials can scratch the
surface of the reflector.
Adding hanging irons and c-clamps to MultiPAR
N o t e :
The hanging irons attach to the MultiPAR. The c-clamp is
bolted to the other end of the hanging iron and then secured
to the hanging pipe.
Loosen and remove the bolt and washer in the end casting.
1.
Attach the hanging iron to the MultiPAR with the bolts and washers provided.
2.
Be certain to attach the longer section of the hanging iron to the
Figure 6
MultiPAR and the shorter section to the c-clamp.
Make sure the smaller length of the hanging iron is secured over the MultiPAR
3.
fixture body when attaching it to the unit.
The C-clamp attaches the fixture to the mounting pipe.
4.
Tightly fasten the C-clamp to the yoke with the provided yoke bolt and lock
5.
washer.
Place the C-clamp on mounting pipe, then tighten the pipe bolt to secure it.
6.
Tighten the pan screw to lock the fixture into position.
7.
www.BulbAmerica.com
or CALL TOLL FREE 888-505-2111
Figure 5
Source Four MultiPAR • 5
Figure 5
Figure 6
Advertisement
Table of Contents
