Table of Contents
Advertisement
ORDER DIRECTLY TODAY AT:
Accessories
Color frame 7.5 in. sq./6.7 in. inside diameter)
Safety cable (31 in.)
C-clamp
Very Narrow Spot lens
Narrow Spot lens
Medium Flood lens
Wide Flood lens
Set of four Source Four PAR lenses
(VNSP, NSP, MFL, WFL)
Changing Source Four MultiPAR lenses
Removing a lens
Disconnect power from the fixture before attempting to remove or install a lens.
1.
Source Four MultiPAR lenses become hot while in operation. Let the fixture cool
2.
before handling the lens.
Place the fixture on a flat, stable work surface.
3.
Tilt the front of the fixture down at least 45 degrees.
4.
Press one (or both) of the spring clips with your finger(s) to release the lens.
5.
(
).
Figure 2
Allow the lens to drop forward from under the clip.
6.
When the lens drops, remove your finger, maintain pressure on the clip while
7.
sliding your finger(s) off the clip. Allow the lens to slide forward until you can grip
it securely.
Carefully remove the lens from the fixture.
8.
Installing a lens
Position the fixture with the front of the unit (the lens side) facing you, and tilted
1.
up slightly (
).
Figure 3
Hold the lens by the edge, and position it so the convex side faces the back of
2.
the fixture
.
Figure 4
N o t e :
Installing the lens with the convex side out will not impair the
optics, but it will make removing the lens more difficult.
From the top of the fixture, slide the lens behind one of the lens clips and into the
3.
cast metal lens channel.
Gently push the top of the lens inward until it snaps behind the other lens clip
4.
C A U T I O N :
Never operate the Source Four MultiPAR without a lens
in place.
Change lenses if they become cracked or badly
scratched.
4 • Source Four MultiPAR
www.BulbAmerica.com
or CALL TOLL FREE 888-505-2111
ETC Part #
7061A3047
7060A1022
7060A2009
7061A4002
7061A4003
7061A4005
7061A4006
7061A1013
Figure 2
Figure 3
Figure 4
Advertisement
Table of Contents
