Resetting - Mercedes-Benz S-Class Operator's Manual

Turn the SmartKey to position 1 or 2 in the
X
ignition lock ( page 189).
Y
MAGIC SKY CONTROL switches to the sta-
tus it was set to before the engine was
switched off.
To change the degree of transparency:
X
press button :.
If the rear MAGIC SKY CONTROL element is in
a different state than the front element, the
degree of transparency will change only in the
front element. Both elements will then be in
the same state and any further changes will
again occur synchronously.
i
At sub-zero temperatures, the change is
slower and uneven. The entire process may
take some time.
Operating the rear MAGIC SKY CON-
TROL element from the rear
To change the degree of transparency
X
of the fully opened roller sunblind: press
switch :.
To change the degree of transparency
X
of the fully closed roller sunblind: pull
switch :.
The degree of transparency will change
only after the roller sunblind is opened.
i
If the rear roller sunblind closes when the
rear MAGIC SKY CONTROL element is not
tinted, this tints automatically.
Panorama roof with power tilt/sliding panel
Resetting the sliding sunroof and the
roller sunblind
Resetting the sliding sunroof or the
front roller sunblinds
Reset the sliding sunroof or the front roller
sunblind if the sliding sunroof or the front
roller sunblind does not move smoothly.
Turn the SmartKey to position 1 or 2 in the
X
ignition lock (
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow :
until the sliding sunroof is fully closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Pull the 3 switch in the direction of
X
arrow : repeatedly until the front roller
sunblind is closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Make sure that the sliding sunroof
X
(
Y
(
Y
If this is not the case, repeat the steps
X
above again.
page 189).
Y
page 111) and the front roller sunblind
page 113) can be fully opened again.
115
Z