Mercedes-Benz S-Class Operator's Manual page 263

if the camera lenses are dirty or covered.
R
Observe the notes on cleaning
( page 416)
Y
if the vehicle components in which the
R
cameras are installed are damaged. In this
event, have the camera position and setting
checked at a qualified specialist workshop.
Do not use the 360° camera in this case. You
can otherwise injure others or cause damage
to objects or the vehicle.
The guide lines in the COMAND display show
the distances to your vehicle. The distances
only apply to road level.
In trailer mode, the guide lines show the dis-
tances at the level of the trailer coupling.
The cameras in the front and in the rear area
are each protected by a flap. These flaps are
opened when the 360° camera is activated.
Observe the notes on cleaning (
For technical reasons, the flaps may remain
open briefly after the 360° camera has been
deactivated.
Activation conditions
The 360° camera image can be displayed if:
COMAND is switched on (see the separate
R
operating instructions)
The 360° Camera 360° Camera function is switched on.
R
i
If the 360° camera is activated at speeds
above approximately 19 mph (30 km/h), a
warning message appears.
The warning message disappears if:
the vehicle's speed falls below approx-
R
imately 19 mph (30 km/h). The 360°
camera is then activated.
the message is confirmed with the %
R
button.
Switching the 360° camera on and off
using the button
To switch on: press button :.
X
Depending on whether position D or R is
engaged, the following is shown:
full screen display with the image from
R
the front camera
page 416).
full screen display with the image from
Y R
the rear view camera
To deactivate: press button : again.
X
i
You can also switch to the split-screen
view from the full-screen view.
Activating the 360° camera with
COMAND
Press the Ø button in the center con-
X
sole.
The vehicle menu is displayed.
To select the 360° camera: turn and press
X
the controller.
Depending on whether position D or R is
engaged, the following is shown:
a split screen with top view and the
R
image from the front camera or
a split screen with top view and the
R
image from the rear view camera
Further information on the COMAND control-
ler can be found in the separate operating
instructions.
Driving systems
261
Z