Winnebago 2015 Journey Operator's Manual page 108

SECTION 7 –
PLUMBING
• Install the diverter plug into the filter socket as
far as possible and twist "clockwise" one-
quarter turn until it stops.
2. Remove the filter canister from the Full-
Coach Water Filtration system in the water
service center and discard the filter cartridge.
After removing filter, remount the empty
canister onto the filter assembly and continue
the Antifreeze Fill Procedure.
Set Up Winterization Valves
3. Turn Winterization Valve 1 to "Water Heater
Bypass" position to avoid filling water heater
with antifreeze. If your coach is equipped with
a Tankless Water Heater, skip this step and
proceed to the next numbered step.
Winterization Valve 1
(See "Water System Drain Valve Locations" chart
at the end of this section for location on your coach)
4. Turn Winterization Valve 2 to the "Winterize"
position.
7-20
Diverter Plug
.
Winterization Valve 2
(See "Water System Drain Valve Locations" chart
at the end of this section for location on your coach)
5. Remove and save the protective cap from the
end of the antifreeze siphon tube (which
connects to Winterization Valve 2). Insert the
end of the siphon tube into a pail or other
container with 2 to 5 gallons of non-toxic RV
antifreeze solution.
RV Antifreeze Siphon Tube
(Located near water pump - second
compartment on driver side of coach)
• Insert into container of RV water system antifreeze
NOTE: Ensure that all drain valves are
CLOSED before pumping RV antifreeze
into the water system.
Refer to the "Water System Drain Valve
Locations" chart at the end of this
section for valve locations on your
model.
Fill Lines
6. Turn the Water Pump switch on.
7. Open each hot and cold water faucet handle/
knob in the coach – one at a time each in turn
until antifreeze solution just begins to flow
.