Installing The Unit - Kenwood DDX7015BT Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Supplied accessories for installation
1 Wiring harness x 1
2 Trim plate x 1 * 1
3 Extension wire (2 m) x 1
4 Flat head screws (M5 x 7 mm) x 6 *
5 Round head screws (M5 x 6 mm) x 6
6 Steering Remote cable x 1
7 Microphone (3 m) x 1
8 Fixture for HDMI/MHL connector x 1
9 Screws for fixture (M2.6 x 6 mm) x 1
0 Film antenna x 1 *
3
- Amplifier unit (cable with booster, 3.5 m) x 1 *
= Cable clampers x 3 *
3
~ Cleaner x 1 *
3
* 1 Only for DDX7015BT Region 4/DDX5015BT/DDX5015DAB.
* Only for DDX7015BT/DDX7015BTM/DDX5015DAB/DDX5015BT/
2
DDX515BT/DDX515BTM.
* Only for DDX5015DAB.
3
62
Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wiring harness wires in the
following order: ground, battery, ignition.
3
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
7
Reconnect the
8
Press the reset button.
9
Configure <Initial Setup>. (Page 4)
·
· battery.

Installing the unit

Installing the unit using the mounting
bracket removed from the car
4 or 5
• Select the appropriate type of screw for the
mounting bracket: flat head (4) or round head
(5).
Installing the trim plate (Only for
DDX7015BT Region 4/DDX5015BT/
DDX5015DAB)
1
Attach the trim plate ( ).
2
Car Bracket
4 or 5
2