Kenwood DDX7015BT Instruction Manual page 63

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection
Connecting wires to terminals (DDX7015BT/DDX7015BTM/DDX5015BT/DDX5015DAB/DDX515BT/DDX515BTM)
USB terminal (0.8 m):
Pages 65 – 66
Pages 65 – 66
Page 66
Connect the antenna
cord to the antenna
terminal.
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Antenna control wire)
Blue with white stripe (Power control wire)
Brown (Mute control wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
6
Page 67 Pages 65 – 66
10 A fuse
*
(ACC)
(BATT)
(GND)
Connect to the vehicle's steering remote harness.
Contact your Kenwood dealer for details.
Connect to the vehicle's reverse lamp harness when
Purple with white stripe
using the optional rear view camera.
(Reverse sensor wire)
Light green (Parking
sensor wire)
3
* If no connections are made, do not let the cable come out from the
tab.
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its power control terminal.
Not used.
To use the steering wheel remote control feature, an exclusive remote adapter
(not supplied) matching your car is required.
To car light control switch
To car chassis
Connect to the vehicle's parking
brake detection switch harness.
• For best safety, be sure to
connect the parking sensor.
Ignition key switch
Fuse box
Battery
ENGLISH 63