Kenwood DDX7015BT Instruction Manual page 67

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connecting microphone for Bluetooth
Connect the microphone (7) to the MIC terminal.
• To install the microphone, peel off the adhesive
tape, fix on the installation position, then adjust
the direction of the microphone to face the driver.
After installing, fix the microphone cable to the car
with clamps (commercially available).
Installing the Digital Radio antenna
(only for DDX5015DAB)

Caution
• This film antenna (0) is exclusively for use inside
the vehicle.
• Do not install in the following locations:
– Where it may block the driver's view
– Where it may obstruct the operation of safety
devices such as air bags
– On movable glass surfaces such as rear hatches
– On the side of the vehicle (e.g. doors, front-side
windows)
– On rear windows
• Signal strength will decrease in the following
locations:
– On IR reflecting glass or where covered with
mirror type glass film
– Where it overlaps with the standard radio
antenna (pattern)
– Where it overlaps with window heating wires
– Where glass that blocks radio signals (e.g. IR
reflecting glass, thermal insulation glass) is used
7
• Poor reception may occur:
– Due to noise when the windshield wipers, air
conditioner, or motor is turned on
– Depending on the location of the broadcast
station in relation to the vehicle (antenna)
• Thoroughly wipe oil and dirt from the surface
where the antenna will be attached with the
included cleaner (~).
• Do not bend or damage the film antenna (0).
• It may not be possible to install the antenna in
some types of vehicle.
• Check the cable routing of the film antenna (0)
and amplifier unit (-) before attaching.
Installation overview
The antenna should be installed on the passenger
side for safety.
ENGLISH 67