Factory Reset - Elektron analog four Getting Started Manual

PATTERN SCALE
The length and timing of the pattern can be changed on this screen. The leftmost figure shows the number of steps
in the pattern. The maximum number of steps is determined by the total length, which is shown on the right. The
rightmost figure controls the time signature of the pattern. If 17 steps or more are used in a pattern, the [PAGE] key can
be used to toggle between the different pattern pages when in GRID RECORDING mode.
1 Press [FUNCTION] + [PAGE] to access the scale screen.
2 Use the [ARROW] keys [LEFT] and [RIGHT] to toggle between step length/total length or time signature.
3 Use the [ARROW] keys [UP] and [DOWN] to change the settings. The
PATTERN SWING
Adjust the swing setting of the pattern, in order to employ a propulsive, rhythmic groove. Access this screen by pressing
[FUNCTION] + [KEYBOARD B1].
Set the SWING ratio to 51-80%, by turning the
setting is equal spacing, 50%.
MULTI MAP
Multi map allows custom mapped keyboards splits, pattern trigging per key, Sound trig per key, MIDI trig of external
synths, and more. With a multi map, full analog drum kits, bass lines, and lead sounds can be played simultaneously
on an external MIDI keyboard connected to the Analog Four. To activate the default multimapping of an external
keyboard, do as follows:
1 Open the GLOBAL menu by pressing [FUNCTION] + [KEYBOARD C2].
2 Highlight MIDI CONFIG, the fifth item in the list, and press [YES/SAVE].
3 Select MULTI MAP EDIT and press [YES/SAVE]. If you wish to use the default multi map, a keyboard split, select
CREATE SPLIT and press [YES/SAVE].

FACTORY RESET

When performing a factory reset on the Analog Four it will overwrite and re-initialize the active project (including all
pattern, kit, sound pool and global data). The +Drive project slot 1 will be overwritten and re-initialized. Sound bank A
and B will be overwritten with the factory Sounds. Factory preset patterns, kits, Sounds and settings will be re-initialized.
If you wish to keep the active project, remember to save it to a +Drive project slot higher than 1 before you perform a
factory reset.To perform a factory reset, hold [FUNCTION] pressed while turning on the Analog Four. In the menu that
appears, press [TRIG] key 3.
16
LEVEL
knob or by pressing [ARROW] keys [UP] or [DOWN]. The default
LEVEL
knob can be used to change settings as well.