Table of Contents
Advertisement
In the LAN socket, there are two LEDs embedded:
Power LED (orange color)
This LED is used to indicate whether DC power is on or not.
LAN LED (green color)
This LED will be flashing while network accessing via Ethernet.
Sometimes restarting the device will m ake the system back to a normal state.
However, if the system still got problems af ter restart, user can restore the
factory default settings and install it again.
Factory
Default
6
Reset
Note:
included IP address forever. User needs to run the IPWiza rd II program to
search the device and configure it to let the device work properly again.
The Internet Camera provides a terminal block with 6 pins of connectors for DI,
DO, and RS485. Please refer to the
information.
Cable for I/O connectors:
DI/DO
7
Connector
The Internet Camera also provides composite video output. Th e video o utput
function is only for easy installation to check view angle and focus. The output is
8
Video Out
not a Mega-pixel resolution. Furthermore, the video output is off by default. To
turn on video, please refer to Setting\Camera\Picture chapter.
The Internet Camera supports DC-Iris control.
9
DC Iris
Restore the device:
1.
Make sure the Camera is ready first. Insert the p aper clip o r other
suitable tool to press and hold the button down continuously.
2.
Hold it lea st 5 se conds and release the tool. Then the device h as
been restored to default settings and reboot again.
Restoring the factory default set ting will lose the all previous
Name
Number
12VDC
1
DI
2
GND
3
DO
4
485+
5
485-
6
User's Manual of ICA-2200
Appendix A in this manu al for more
Function
DC 12V (50mA maximum)
Digital signal input
GND
Digital signal output
RS485 data +
RS485 data -
10
settings
Advertisement
Table of Contents
