Softkeys, Programmable Keys, Expansion Module Keys; Action Uri - Mitel 6800i Series Administrator's Manual

Softkeys, Programmable Keys, Expansion Module Keys

A user or administrator can assign specific functions to softkeys, programmable keys, or expansion module keys. The avail-
able keys for configuration depend on the IP phone model as shown in the following table.
IP Phone Model
6863i
6865i
6867i
6869i
*The M680i expansion module consists of 16 softkeys. You can have up to 3 expansion modules on an IP phone totalling 48
softkeys. Valid for 6865i, 6867i, and 6869i phones.
**The M685i expansion module consists of 3 pages of 28 softkeys (for a total of 84). You can have up to 3 expansion modules
on an IP phone totalling 252 softkeys. Valid for 6865i, 6867i, and 6869i phones.
The softkey, programmable key, or expansion module key can be set to use a specific function. Available functions depend
on the IP phone model.
Reference
For more information about key functions see Appendix A, the section,
sion Module Key/Hard Key Parameters"
For information about configuring softkeys, programmable keys, and expansion module keys, see Chapter 5, the section,
"Softkeys/Programmable Keys/Expansion Module Keys"

Action URI

The IP phones have a feature that allows an administrator to specify a uniform resource identifier (URI) that triggers a GET
when certain XML events occur. The Action URI feature prevents the phones from hanging if the Action URIs should fail.
The phones also support transparent, non-blocking, XML post execute item URIs.
The IP phone XML events that support this feature are defined in the following table.
Action URI Description
Startup Specifies the URI for which the phone executes a GET on when a startup event occurs.
Successful Registration Specifies the URI for which the phone executes a GET on when a successful registration event occurs.
Registration Event Specifies the URI for when registration events occur or when there are registration state changes.
Note:
This action URI is not called when the same event is repeated (for example, a timeout occurs again when registration is
already in a timeout state.)
Incoming Call Specifies the URI for which the phone executes a GET on when an incoming call event occurs.
Outgoing Call Specifies the URI for which the phone executes a GET on when an outgoing call event occurs.
Offhook Specifies the URI for which the phone executes a GET on when an offhook event occurs.
Onhook Specifies the URI for which the phone executes a GET on when an onhook event occurs.
41-001561-00 REV00 – 10.2014
Softkeys
-
-
10
17
on page A-174.
on
Administrator Level Options
Expansion Module Keys
Not Applicable
16 to 48***
(Model M680i)
84 to 252****
(Model (M685i)
16 to 48***
(Model M680i)
84 to 252****
(Model (M685i)
16 to 48***
(Model M680i)
84 to 252****
(Model (M685i)
"Softkey/Programmable Key/Keypad Key/Expan-
page 5-104.
Programmable Keys
3
8
-
-
3-41